HK416 A7 CQB

A simple mod I am releasing again for everyone, which I have taken the mesh of the 416 assault handguard and shorten it to replicate the SBR HK416A7, so now you don't have to wave around a 20 inch barrel in close quarter buildings. This gun will replace the SIG 516 CQC. I have also included a change in the sights. Changelogs will be listed below.

Changes made to the 516 CQC:

-Hartman reflex sight swapped with Holo w/ G33 magnifier

-Comp M4 sight swapped with Micro T1 dot w/ G33 magnifier

-Handguard mesh has been shortened

-Added cosmetic flashlight to the railguard

If you are using planeguy121's Geissele URG-I (ish) mod, I will include a separate file to download, as the textures will conflict if you use the first file. Do not come into the comments complaining about the handguard's texture being a rainbow because I will NOT reply if you do. Its your own fault for not reading the big ass "NOTE" I put into the description.

Tutorial copied from Tenabrea

File Swap Tutorial - DataPC_Resources_patch_01

Installation:

• []Download and install AnvilToolkit.[/]

  []Set up Anvil Toolkit, disable the use of compression in Settings->Files 

  and

   set compression ratio to 0.[/]

  []Unpack DataPC_Resources_patch_01.forge[/]

  []Open Extracted folder in your GRB directory and open the DataPC_Resources_patch_01.forge folder.[/]

  []Copy the .data folders into the DataPC_Resources_patch_01.forge folder.[/]

  []Right-click the folder, and select "Repack" - you should see the message

  Successfully written forge file![/]

  []Done for this part[/]

  Installation Tutorial - DBContainerEntry

  Installation:

  []Download and install AnvilToolkit.[/]

  []Set up Anvil Toolkit, disable the use of compression in Settings->Files 

  and

   set compression ratio to 0.[/]

  []Unpack DataPC_patch_01.forge[/]

  []Open Extracted folder in your GRB directory and open the DataPC_patch_01.forge folder.[/]

  []Unpack 1_-_DBContainerEntry_0X....... (should be near the top). This may take a few minutes, its a big file[/]

  []Copy the loose files from the mod download into the new unpacked DBContainerEntry folder. If you want a backup, look for the identically named files that are already in there (the numbers in front are a good way to search) and save them elsewhere.[/]

  []Select the DBContainer folder in AnvilToolkit, right-click, and select "Repack" - you should see the message (This may take a few minutes. Be patient)

  Finished repacking data file | Successful: 01 | Failed: 0[/]