Alcohol Fuel Mixer

This is a script for mixing liquid alcohol and oxygen into a gas pipe network to be an alcohol fuel mix. Ideally this will feed a composter so that you can burn and make water. There is a youtube video posted with this to help explain this since this is relatively new and we havent really needed a liquid + gas mixer for anything. This is part of the plant gas loop now to make stable water. What you need: 2 Gas analyzers 1 volume pump 1 liquid volume pump 1 liquid analyzer. 1 expansion valve Pins: d0 = Fuel Analyzer d1 = Oxygen Analyzer d2 = Oxygen Volume Pump d3= Alcohol Analyzer d4 = liquid volume pump. I am presuming that you already have a setup to use a fermenter to make alcohol. This script will work with a pure alcohol or a alcohol + Polluted water mixed pipe in the event that you chose not filter out the polluted water. The script will mix and make sure to have a 1 alc to 3 oxygen mix in the fuel mix pipe network. The fuel mix pipe network does not need to be high volume because the script calculates how much of the total volume the fuel mix has and will seek to have enough alcohol in it to reach 50% stress. It will then calculate how much oxygen is needed to make the proper mix at this ratio. Because of this the fuel mix pipe should be somewhere around 1. 2MPa of pressure. More volume just means you have much more alcohol in the fuel pipe which may just sit around not really doing anything. As far as safeties are concerned, it will not add alcohol to the fuel mix pipe if the pressure drops below 250kpa. This is to ensure that the alcohol will not evaporate and become methane in the fuel mix. At the moment, I also have it not attempt to add alcohol if there is less than 5L of liquids in the alcohol liquid pipe network. The script also will see how pure the liquids are between alcohol and polluted water. The script will auto adjust the flow to account for the smaller alcohol density in the liquids to ensure the flow of alcohol to the fuel mix is steady.