[F&S] Full Auto Airlock

Description Fully automated airlock, just build and forget. Works in all kinds of modes, atmosphere to vacuum, atmosphere to atmosphere, vacuum to vacuum. Automatically equalizes pressure between transitions to different parts of the base (Unlike a in-game advanced airlock, there is no need to adjust the pressure in the console for the external and internal atmosphere, everything is automated). Can work even if the pressure is not constant and changes rapidly. Supports bypass mode. Works faster than built-in game airlock. Prevents the atmosphere from passing into a pure vacuum room (So you don't have to worry about leaking a few cmol of gas.) Requirements 3 Gas Sensor. 1 IC Housing. 1 Integrated Circuit (IC10). 1 Kit (Logic I/O) (Logic Reader) 1 Area Power Controller or Transformer. 1 Battery Cell (Large). 2 Doors any type. 2 Active Vent. 3 Kit (Switch) (Lever) (Optional) IC ports description Port Device D0 DoorInt (Internal Door) D1 DoorExt (External Door) D2 GasInt (Internal Gas Sensor) (Optional not required) D3 GasExt (External Gas Sensor) (Optional not required) D4 VentInt (Internal Active Vent) (Optional not required) D5 VentExt (External Active Vent) (Optional not required) Changeable values in IC code none Important You must separate the electrical lines with a transformer or APC, otherwise IC10 may read incorrect values. Kill Switches are optional but strongly recommended option. It is recommended to place a APC with a battery, so as not to get stuck in the airlock when the power goes out. For faster operation of the airlock, you should connect buffer with gas, and not just place passive ventilation. See screenshot 3 (Yes, you can leave out the pressure regulator, but sometimes the pipe can explode) Don't forget to connect the logic reader to the gas sensor in the airlock var = pressure. Airlock size limited to 1 cube (because it is difficult to determine the movement of the atmosphere inside the airlock with just 1 sensor). Emergency Kill