[F&S] Room Temperature Control

Description Allows you to control the temperature in the room within the specified limits. This scheme works fine in small rooms and use hysteresis method to prevent unwanted rapid switching. Requirements 1 IC Housing. 1 Integrated Circuit (IC10). 1 Gas Sensor. 1 Dial. (Optional not required) The dial works in the range of 0C - 45C At least one Cooler. (Connected pipes must be under pressure (CO2 are best choise) and have radiators in the external environment) (Support Gas/Liquid coolers) At least one Heater. IC ports description Port Device D0 Gas Sensor D1 Dial. (Optional not required. If not mounted then the standard temperature will be 21C) D2 Alert. (Optional not required. Turns on the specified device. You can use any device that supports On/Off) Changeable values in IC code define DesiredTemp 21 # temp in celsius define HysteresisWindow 2 # temp difference +-2 define CheckVolatiles 1 # 1=yes,0=no define VolatilesRatio 0. 0003 # 0. 03% on tablet Chip states State Description 0 All fine 1 Low pressure (If pressure less 7 kPa IC Chip will not turn on temperature control and will sends a signal to port D2) 2 Detected more then 0. 03% of volatiles in atmosphere, automatically shuts off heaters (coolers will still work) and sends a signal to port D2. 3 Temperature too high (if the temperature is set to 21, and the gas sensor shows 31, sends a signal to port D2) 4 Temperature too low (if the temperature is set to 21, and the gas sensor shows 11, sends a signal to port D2) Important It is strongly recommended not to disable or change the volatiles checker. Insulated pipes must be laid in the room so as not to receive heat leakage. For best results don't place gas sensor near cooler/heater. Game version support 0. 2. 3920. 18842 06/04/2023