Multi-silo Control V2

As described in my other workshop, silos for ore are in the ground floor basement. This allows remote selection and dispensing of ores from the silos. I have chutes that run up the back of the elevator shaft and an output port is on the main floor next to the furnace. (In hindsight, maybe I should have put the furnace in the basement too). To connect the IC use the following: d0 dial selector (set to a max of 2. selections are 0, 1 and 2) d1 button d2 Console (with hash display board) Console must be set with data disk to monitor IC Housing d3 silo X d4 silo Y d5 silo Z I used a tier system and needed three of these to dispense 9 ores. I do not use this for ice as it would melt before it got to the output port. The hash numbers for all ores are in the comments so that you don't have to look them up in Stationpedia while customizing your code for your setup. NOTE: You will have to edit this code to put the correct hash​ for the silos connected to X, Y and Z, but it is simply a matter of putting the correct number in the hash definitions at the top of the code (see Define statements). I have found that to request multiple requests of the same ore, say I want 6 stacks of iron for making steel, I have to pause between button pushes. For example, push the button, count 1, 2, 3 push the button. Otherwise the silo isn't finished opening and closing before you press the button again. I could use a dial to indicate the number of stacks of ore you wanted dispensed, but that would take another IC input slot, requiring more of these to get to all 9 ores. So, this is a compromise.