Easy Super-Flexible Climate Controller

Easy Super-Flexible Climate Controller Assign devices to any screw you like! Device types are auto-detected via their unique PrefabHash. This climate control script aims to be the most flexible and easiest to set up available. There are only a few requirements and limits on what or how many devices can be attached. Here is the list of device types that will be recognized, followed by further details on usage, limits, etc: 1. A Dial (Logic Switch kit). If one of these is found it will be used to input the temperature to maintain, in Celsius. Ensure that the dial's range is set high enough that your desired temperatures can be selected. See the "Control Device Options and Limits" section below. 2. A Logic Memory unit. If one of these is found, the stored value will be interpreted as the desired temperature in Kelvin, allowing automatic adjustment of climate control from other scripts or circuits. See the "Control Device Options and Limits" section below. 3. One or more Gas Sensors. Any gas sensors assigned to a screw will be used to get the current temperature reading. If more than one is assigned, their readings will be averaged, without requiring a batch reader. (Be sure to name the sensors uniquely so you know you've selected different devices!) See the "Sensor Requirements and Limits" section below. 4. A Batch Reader. If a batch reader is assigned instead, its output value will be interpreted as the average of the temperature readings from its connected gas sensors. It should be configured to match. See the "Sensor Requirements and Limits" section below. 5. Wall Heaters and Wall Coolers. Any of these which are assigned to a screw will be directly controlled as needed with no further restrictions or requirements (although the limited number of screws does impose its own restriction). 6. One or two Batch Writers. If present, these will be used to control wall heaters and wall coolers. They must be configured to write to the "On" parameter of the respective device ty