V22 Osprey XL -Part1-

Bell-Boeing V22 Osprey XL -Part1- For COMLEXITY MOD only! I finally decided to share one of my craziest builds. This V22 Osprey is made of three parts, has a complexity over 2000 and is really high detailed. Only heli engines and some props are used! No gimbals! To get this thing ready I have spent several weeks. The Osprey is a tilt rotor VTOL aircraft which is usually used for cargo or troop transports. Because of the ability to hover it can do starts and landings almost everywhere. On the other hand it is able to fly as fast as a normal plane. Like the original Osprey it is a flying computer and full of countless logic gates, so you will have many keybinds. I tried to keep it simple: Many functions are automatic, so the basic keybinds you will need to fly are only a very few… The holding forces of the rotor tilt servos are on its limits, so it could shake a little bit… When you use it, you almost can’t do anything wrong -except to switch off the engines ;-) Features: -Two seats in the cockpit - Two seats in the cargo area – FPV-Gun with one seat – two-piece cargo door – Two-piece front door for crew - Automatic retractable gear with some doors – Automatic swap of the steering from heli mode to plane mode and driving on ground – Automatic degrease of speed before touchdown – High hold mode – Rotor tilt in two steps to semi transition and full transition (to plane mode)– full stabilized heli-and semi transition mode – Magnet inside and outside to fix the stuff – moving screen wiper arms – cockpit ready for FPV use – Detachable second front seat – Three bladed rotors – Lift is controlled by rotor pitch Connecting parts: Set complexity mod to 2100 and load the centre part (#2) into the builder. Then load the nose part (#1) without deleting blocks. Connect the nose in the right alignment to the centre. Finally do the same with the rear (#3). Connect it to the back side of the centre. Deselect all and wait for calculation. Press B to spawn the whole thing it in the gam