Puck Mk II

A wheeled/hover/sub transformer that uses (mostly) the same controls in both wheeled and hover mode. The design goal behind this transformer is to make transformation and operation as simple as possible. There are no sequences of key presses to activate the features. The control configuration is automated based on the physical position of the transforming parts of the vehicle. Various distance sensors have been placed on the vehicle to enable a series of logic blocks embedded in the hull. The position of the sensors determines which controls are active. Once the pilot is accustomed to these features it becomes very easy to transition between land, hover, and sub modes. Pilots will find themselves slipping in and out of various environments with ease. Controls: Transformation and Illumination 1 - activates hover mode, unless already in hover mode, then will activate wheeled mode 2 - activates sub mode, unless already in sub mode, then will activate wheeled mode 3 - toggles head/tail lights (Lights are off by default.) Wheeled Mode W - forward S - reverse A - left D - right Space - activates jets and submersible engines Hover Mode W/Space - forward (activates jets and submersible engines) A - left D - right Submersible Mode W - pitch up S - pitch down A - roll left D - roll right Space - forward (activates jets and submersible engines) NOTE: Submersible mode is new to Puck and still a work in progress. Maybe a future version will operate better underwater. At any rate, you're going to want to keep moving or you'll hit the sea floor. Puck will "drive" and "hover" underwater if you happen to get too close to the bottom. Puck can also transition from the water to hovering with a little practice. I hope you enjoy Puck Mk II! Any feedback is appreciated! Check out my other designs: https://steamcommunity.com/id/shoutlander/myworkshopfiles/?appid=585420 Here is a direct link to the Mark I (wheeled/hover modes only): https://steamcommunity.com/sharedfiles/filedetails/?id=175