Stationeers Methane Combustion Fix

This mod is a BepInEx plugin. It requires BepInEx with the StationeersLaunchPad plugin to be installed (see Installation below). Stationeers Methane Combustion Fix Fixes incorrect methane combustion reactions to be chemically accurate. Notes: Works with existing saves. The mod does not modify save files, so it can be safely enabled or disabled at any time. Applies corrections at the reaction-definition level, so fuel allocation, consumption, and exhaust calculations use consistent stoichiometry. A correctly mixed welder therefore leaves no unburned fuel. Corrects the methane + oxygen fuel mixture in starting and respawn equipment by default. Disable PatchStartingFuelMixtures in the mod configuration to opt out. Tested with the Gas Fuel Generator (GFG). Combustion reaches the expected 90% ratio. Installation If you haven't already, follow the StationeersLaunchPad installation guide to install StationeersLaunchPad and BepInEx. Press Subscribe above. StationeersLaunchPad will pick up this mod automatically on the next launch. Methane + Oxygen Replaces the incorrect reaction: 2 CH4 + O2 -> 6 CO2 + 3 Pol With the correct reaction: CH4 + 2 O2 -> CO2 + 2 H2O Recommended fuel mixture: 33% methane, 67% oxygen. Always enabled. Methane + Nitrous Oxide Replaces the incorrect reaction: CH4 + N2O -> 2 CO2 + 2 N2 With the correct reaction: CH4 + 4 N2O -> CO2 + 2 H2O + 4 N2 Recommended fuel mixture: 20% methane, 80% nitrous oxide. Enabled by default. Can be disabled in the StationeersLaunchPad configuration window or in BepInEx/config/StationeersCombustionFix.cfg (BepInEx is located in the game folder, e.g. C:\Program Files (x86)\Steam\steamapps\common\Stationeers). Methane + Ozone Replaces the incorrect reaction: 3 CH4 + 2 O3 -> 6 CO2 + 3 Pol + H2O With the correct reaction: 3 CH4 + 4 O3 -> 3 CO2 + 6 H2O Recommended fuel mixture: 42% methane, 58% ozone. Enabled by default. Can be disabled in the StationeersLaunchPad configuration window or in BepInEx/config/Statio