TTAC - Trade, Track and Contact

Features: Fully automated trader search, find and contact optional target/specific trader tracking Status overview with everything you need to know for the dish operations optional gas/liquid pump/regulator control including the Landingpad ATMO's Overview: Status display for the dish, tracking, controller and the current tracked contact Control panel for the Landingpad Gas/Liquid In/Outputs including pump/pressure regulator control for each gas/liquid Safe usage buttons - Use one gas group in/out and all others will vanish Contacts: Overview of saved contacts which had been found in the search process Buttons to clear a slot (Clr), track a target (Go) or to select the target (Sel) Selected contact gives you another option to contact that target (Dish will align to the target and try to interrogate) It will also give you an overview of possible ship names for that ContactID Buttons at the top to specific track and contact trader categories like Ore or Gas/Liquid Log: Simple event log listing the last actions and infos Up to 50 entries and they reset with device reboot or script reload Settings: Not much to say here... this is where you set up the devices and pressure settings for the gas/liquid input regulators Devices for each categorie like "Dish" or "O2 Pump" have dropdowns where it lists all devices for you to select the device for that slot Devices in the dropdowns are filtered by hashes so you dont have to scroll through tons of unneeded devices Setup Instructions: Disable Code limits in the IC10 Editor Mod settings Subscribe and flash on a lua chip / best to use in a circuitboard for consoles (I advice to use the 2x2 / 3x3 consoles mod though the ui also scales down for normal consoles) Setup the devices over the settings tab and build (if not done already) your landingpad and other stuff you need for your trader area It can take a few seconds to load and flash the code to the chip as it has a few lines of code You don't have to change anything in the code! Th