Printer Job Automation

​Hey all, I showcased this code in a tutorial video on my channel. Go check it out: https://www.youtube.com/watch?v=ltHIK091eR8 This is part 1 of my automated printer script setup. - Printers will print the selected items x amount of times based on the stacker setting - The stackers on/off is determined by the printers on/off - Includes a reset button to reset the stacker value to 50 - The code accounts for exporting ingots by setting the stacker to 500 automatically when the printer is opened. - Has two LED's, one that shows the stackers setting and another that shows the current export count - Allows for change in stacker setting during printing - Does not use pins allowing the code to operate on a single housing (It used device ID's so there is some initial setup) What you will need: - 6 x Consoles (For LED's) - 3 x Printers (Autolathe, Electronics & Pipe Bender) - 3 x Stackers - 3 x Switch Kits (For buttons) - 3 x chutes (Connect printers to stackers - 1 x Housing - 1 x Circuit for Housing - 1 x Laptop / PC - Cables - Your handheld tablet with a configuration cartridge How to setup: 1 - Build your printers keeping at least a 1 block gap between them 2 - Connect the export slot on each printer to a stacker. 3 - Place 2 LED's above each printer (or somewhere else if you want) 4 - Place a button above each printer (or somewhere else if you want) 5 - Cable it all together to provide power 6 - Place your Housing so the data port is on the same network as all your devices 7 - Export the code onto the circuit via your laptop / PC 8 - Amend the first 15 lines of code (Lines 12 - 26) with the correct device ID's. You can obtain these using your tablet with the configuration cartridge. When looking at the first 15 lines of code, I have placed notes along side each line indicating what the device should be. MAKE SURE YOU CHANGE THE ID's BEFORE YOU RUN THE CODE. FAILURE TO DO THIS MAY CAUSE ISSUES IN YOUR BASE IF ANOTHER DEVICE HAS THE DEVICE ID I HAVE LISTED! My advice is