Automatic Generator

Automatic Generator A lean IC10 script that automatically manages all your Solid Fuel Generators based on total battery charge. Plug in any number of Large/Small Stationary Batteries and Generators—no manual toggling required. Features Threshold-Based Control Turn generators ON when combined battery charge drops below MinPercentage (default 40 %). Turn generators OFF when battery charge rises above MaxPercentage (default 50 %). Continually re-evaluates each tick—no rapid cycling between on/off if your batteries hover between thresholds. Batch Detection (Unlimited Devices) Automatically finds all connected Stationary Battery Large (hash -1388288459) and Stationary Battery Small (hash -400115994) units. Automatically finds all connected Solid Fuel Generators (hash 813146305) and switches them in bulk. No need to re-alias or rename individual devices—just wire everything to the same data network. Optional Overload Alert Compares summed PowerPotential. Maximum against summed PowerActual. Maximum for every battery. If (PowerPotential – PowerActual) < 0 (i.e. your consumption outpaces battery potential), the script turns ON the Alert pin (d0). The Alert device is fully optional—if nothing is plugged into d0, the IC simply skips that write without error. Handles “No Batteries” Gracefully If it detects zero total battery capacity, it assumes 100 % charge so generators stay OFF rather than spamming on/off when no batteries are present. Requirements IC Housing + IC10 Chip containing this script. One or more Stationary Battery Large (-1388288459) and/or Stationary Battery Small (-400115994) on the same data network. One or more Solid Fuel Generators (813146305) on that network. (Optional) Alert device (Flashing Light, Klaxon, LED, etc.) wired into pin d0. If no device is present, the script will skip all Alert writes. Note: All devices must share the same data network as the IC Housing. You do not need to assign individual generators or batteries to specific pins—batch instructi