LArRE (Hydroponics) Hydroponics

*UPDATED* Default perennial list to include strawberries, blueberries, and watermelons. *NEW* Ability to designate stations for LArRE to ignore. *NEW* Control for up to two Linear Rail Doors. Automated harvesting and replanting of crops using LArRE (Hydroponics).​ Basic setup: LArRE (Hydroponics) dock and linear rail stations above hydroponics trays or devices (either work) and an import chute bin. Chute bin can be in between trays. Set pins on IC housing (see configuration below or in code). Adjust variables in code for your specific setup. See code comments for applicable variables. Optional Setup for Grow Light Control: Daylight sensor on the ceiling and grow lights wherever you want. Uncomment* applicable lines of code and adjust sunlight angle as desired. See code comments. *NEW* Optional Setup for Linear Rail Door Control: LR Doors wherever you want (max 2). Linear rail stations immediately on both sides of the door. Can be farm plot stations. Adjust applicable door variables to be halfway between the two stations (ex: if door A is between stations 5 & 6, variable rDoorA should be 5.5). Leave variable as 0 if not using door. Uncomment* line 76 if using door A, and line 77 if using door B. Note: door station numbers must be one apart (i.e. -1 and 0 are fine, 84 and 85 are fine, but 61 and 0 are not compatible). *NEW* Adding Exempt Stations: If you have non-planting stations between the planting stations, such as for an LR door separating your normal greenhouse from your mushroom greyhouse, you can add an exemption in the code. Line 10 shows the example: put db -1 So, if you need to exempt stations 23 & 45, add the lines: put db 22 -1 put db 44 -1 Scripts are limited to 128 lines. If you exceed that, it will start deleting the bottom lines. If you need more lines for exemptions and/or perennials, see 'Flashing the IC Housing' below. You only need to add exemptions if the stations fall between the stackStart and the stackEnd. IC Housing Pins: d0 LArRE (Hydroponic