UPC V1.0

Unified Power Control V1. 01 by BNE Single IC-10 Solar Tracking, Battery Monitor, Fueled Backup Power, Power Monitor Remote Solar Networks Plug&Play no IC Pin Setup For setup instrctions see above images. For users who knows what to do: QUICK Setup (no config): A - place IC10 in your power network. Add DaylightSensor label it DaySensor. Solar Tracking DONE B - optional - Connect to Battery, SolidFuel Generator, mount a gasSensor (gSensorSFG/ and an active Vent (aVentSFG) above the generator, BackpPower installed (enables the SolidGenerator when battery starts to blinking red). C - optional - Attach an Small LED Display, name it PowerDisplay, Monitor Done. it monitors now all wind and solar power generation, the output of the battery, enables the SolidGenerator when battery starts to blinking red. The amount of Fuel Stock in the SFG. D - optional - attach two logic Transmitters name them TransSolarH TransSolarV. Wireless Distribution for remote networks. (its more showcase) a second installation comes cheaper in all regards. more detailed and flexible setup /and way better results: 1.place the IC Housing Data side insode your power-generating network 2.connect IC power behind some kind of battery. 3. place an daylight sensor in same network , flat mounted, facing the sky, cable port north (0°) - label it DaySensor 4. place panels with powerport west / 270° *3-4 for existing setups change codeline 3 define DaySen HASH("DaySensor") # label daylight sensor 11 SENSORDATAANGLE 0 12 PANELPOWERANGLE 270 according to your existing installations. 5. the scriptis setup to readout all normal batteries and use the define sBattery HASH in the code line 16. In Line 17 is sBatteryL with its HASH, either change occurance of sBattery in the code or outcomment line 16 and remove the L in line 17. 6. Backup power is realised with the solid fuel generator, so it needs its data port connected. You may also just replace the HASH with the generator of your choice. Backup Power parameters ar