Filtration Control

Uses diodes to measure filter levels in filtration unit. Keeps track of output pressure of waste output shuts off when waste output reaches 45mpa Gives audible warning if either meets thresholds Setup___ Copy to IC chip Put into Filtration Unit Set pin d0 to LED light Set Pin d1 to Diode Slide Have at least on speaker on same network(will use all speakers on same network) Note: this was intended for in series filtration setup(waste output goes into the next filtration unit) as this filters gasses faster then a parallel system. (Though should work for a parallel system) Added a shut off if there is over pressure above 45mpa so if one unit fails we wont get a over pressure event. "Malfunction Detected" Filter of unit is below 3% "Alert High Pressure" As a suggests pressure is above 45 mpa check LED for which unit to service.