Gas Harvester V3 - Fork

This is a fork of CowsAreEvil's Gas Harvester V3. Original workshop item can be found here: Gas Harvester V3 The reason for forking and uploading this updated version is to fix a few small issues present in the original. Instructions for use: Setup the pins as follows: d0: Gas storage tank d1: Filtration device d2: Pipe analyzer d3: First diode (optional) d4: Second diode (optional) d5: Alarm (optional) Configuration Change MINTEMP, MAXTEMP, and MAXPRESSURE as required. The type of gas being filtered will determine the settings you use. Gases that condense easily, like N2O will require a higher temp and/or lower pressure, whereas gases like Nitrogen are much harder to condense and can have a wider range of temps and higher MAXPRESSURE. Default are set to: MINTEMP 273K (0C) MAXTEMP 323K (50C) MAXPRESSURE 50000kpa On line 125, change 1. 0 to whatever minimum molar count you desire This is highly dependent on your setup. If you have a high pressure differential across your filtration devices, you can set this quite high (e.g. 50. 0), and when the device toggles on it will clear a large percentage of the present gas, and will result in the filtration machine staying off for longer between runs. In this setup, having a minimum mole count of 1. 0 will most likely result in the machine toggling on and off every single tick, which can waste power. Best thing to do here is to play with the number until you find something that works for you Caution: A high minimum mole value on every gas will result in a higher pressure in your input line than a lower value Change the device used to check temperature as required. On line 48, the default device to check temperature is the pipe analyzer, however this can be changed to use the tank itself as required. i.e. change l r1 analyzer Temperature to l r1 tank Temperature The decision to do this will depend on your setup, in particular your method of cooling. Given some gases require very delicate temperature management (e.g. N2O, Volatiles