2023-Filtration without filters..

​This is a filtration system by air conditioners, using state change of the gases. First air conditioner pull the excess cold or heat from entire system and operate with the IC-10 chip, while next seven are for filtering the gases while they go to liquid state. I control all devices by names, so check them from the script. Waste pipe from first one must be cooled by radiators at the start and then it must be heated by pipe heaters, so the system can work . Intake and exhaust pipe is in a loop. Volume pump fill the next AC loop, to maintain the pressure (pressure and temperature is critical for some gasses). Waste pipe is directly connected to previous AC in/out loop, and liquids are drained by the new condensation valve. There is a valve and one pipe segment before the volume pump for the third AC, and so on. This way that one segment got clear from the qurently cleaning liquid, and the pump start if there isn't gas type filtering in previous loop. First and second AC both drain the steam (water) from the pipe. I can upload some pics later. P. S. I use Nitrogen for agent gas .. Oxygen got lowest freezing temperature, but nitrogen is next.. On the pics i got many other volume pumps, purge, expansion and condensation valves and some pipe heaters, wich i use while i find right pressure and temperature. Be careful if use cooling on the cleaned gasses. Especially with nitrous oxide .. on normal temperature (20 degrees celsius) if pressure is above 1 MPa it start to condensate, which lower it's temperature more and finally it freeze bursting the pipes. Usualy I reduce the pressure for it below 950 KPa if i will cool it (like for the nitro-volatiles fuel mix) .. Be warned.