IC10 Internal Filtration [ON/OFF, Pressure Display, Diode Slide & More]

This IC10 script is made for internal Filtration Units (no housing!), if any input gases match with the filters, then the Filtration Unit will be activated. If output pipe pressure is above limit, the Filtration Unit won't be activated. You can also (OPTIONAL) set a Diode Slide to d0 to show the average % of the filters (it is divided by 200 so it's pretty in detail!). You can also (OPTIONAL) add a display to d1 to show the output pressure in Mpa. The default max. output pipe pressure is set to 22Mpa. (Can easily change in script!!) The default min. required input moles that match the gas of the filters is set to 450mol. (Can easily change in script!!!) How to use: Put empty Integrated Circuit into Filtration Unit, go on PC and select Filtration Unit, load script from PC to Filtration Unit. Change screws inside Filtration Unit if u want too: d0 = Diode Slider (Optional) d1 = Display for Pressure (Optional) Extra Info: This script works with all combinations of filters and supports every gas. This script is specific with mols, if Filtration Unit has H2 and N2 filters, then it only activates if there is more than 450mols of H2 or N2, so it will not activate itself when not needed! And not skip being activated when it is needed! Leave a comment for any help! (English only or german only pls)