Combustion Centrifuge Controller (O2/NO2)

This script for IC10 chip can be used to fully automate startup of the combustion centrifuge. ​By default it is pre-configured for NO2/H2 fuel mix, however O2/H2 fuel mix is also fully supported, you just have to change the "TRANSITIONRPM" variable to somewhere around 10-50. Automatics will then kick in and handle everything for you. This script uses two stage startup approach - first at low RPM stage throttle is pulsed to 10% for a second every 2 seconds. Once RPM exceeds 200 (TRANSITIONRPM define) high stage mode is used which regulates throttle in 10% increments depending on stress level, adding when stress is low and reducing when it is high automatically. Usage instructions: Load the script into your IC programming computer. If O2/H2 mode is desired change TRANSITIONRPM variable to 10, otherwise just save the script to IC10 chip. Insert the IC10 chip into the housing inside of the combustion centrifuge. No data network connection needed - all is handled inside the machine, just use the on/off switch on the machine. You may also turn the machine on/off via a data network connection if desired.