AIO Atmospherics Control

All in One - Atmospherics Control v1. 1. 2 by LOG3 -------------- Table of Contents -------------- -Description -Room Setup -Installation -Screw Setup -Script Settings -------------- Description -------------- This IC10 script takes care of the whole atmosphere of a room: -regulating the pressure and temperature -regulating the set gas ratios of N2, CO2 and O2 -venting all other unwanted gasses I tried to make it easy to undersand and flexible enough to be changed according to your preferences. New with v1. 1: Buffer mechanics Temperature/Pressure/Gas ratios now all have a target and buffer value set in the script. Once a value is over/under its target +/- the buffer the system is triggered and react until the target is reached. This acts as a buffer so that the system is not constantly reacting to small changes and spends longer time in idle when everything is within limits. The default Settings should be good to go but if you are not happy you can play around with the appropriate settings. Refer to the Script Settings section. -------------- Room Setup -------------- This script works with active vents for both intake and exhaust and wall coolers and wall heaters. Your room needs: -access to a filtration loop where every gas is filtered. -2 active vents for sucking up the air in the room back into the filtration loop. Unwanted gasses should be either stored or vented outside. -3 active vents, one for each gas in the atmosphere: N2, CO2 and O2 which supply the room with these wanted gasses. -at least 1 wall cooler and 1 wall heater and these should be the only ones connected to the IC10 network. Notice: It should be possible to rework the script for other solutions with minimal changes: -You could replace the 3 active intake vents with volume pumps and combine the pipes into a single passive vent but you will need to alter the script slightly by deleting the section where it sets the vent modes and vent pressures. -You could use other forms of heating/cooling as long