Satellite Signal Classifier

​Spend More Time Finding Traders and Less Time Finding Satellites! Using buttons, you can classify satellite dish signals as either trader or junk and this code will remember that and skip over junk signals when dish finds them in future.​ Eventually this means your dish will only ever track in on signals you marked as traders and will automatically ignore everything else. Hardware This script should be deployed onto an IC10 which works as a co-processor alongside the satellite dish setup from the wiki: https://stationeers-wiki.com/Satellite_Tracking It will need a LED and 2 buttons and will also connect to the dish and to the diode slide used by the wiki script. For convenience put the buttons and LED near to the computer where you have the comms motherboard installed. Usage The LED will light red for junk signals and green for traders (yellow means this signal is not yet marked as either - use the buttons to do that!) It is best to wait until the dish finishes tracking before marking a signal to ensure it's tracking the one you think it is (sometimes they can be very close together and it may be tracking one that is currently not the highest percentage on the computer) Made A Mistake? A signal can be re-classified any time by clicking the correct button, but you'll need to be quick with signals incorrectly classified as junk because it will skip them as early in the tracking as possible! So be careful with what you mark as junk :)