Automated Advanced Furnace

Fast and Efficient Automated Advanced Furnace When the ic 'Setting' variable is greater than zero, controls the temperature and pressure inside the furnace to fit within a certain range by pumping hot gas, cold gas or reusing waste Optimized for speed (reach the desired range fast) and efficient use of the gases. Pin configuration: d0 Waste Tank (or Pipe Analyzer) d1 Turbo Volume Pump (Gas) for Coolant d2 Turbo Volume Pump (Gas) for Hot Gas d3 Turbo Volume Pump (Gas) for Waste Tank (preferred gas to use waste from the furnace itself or other sources) d4 Memory Temperature Range (or any other logic device with 'Setting' variable) d5 Memory Pressure Range (or any other logic device with 'Setting' variable) Temperature Range is defined as following 000600. 100000 = 600 Kelvin to 100000 Kelvin the integer part of the number is the minimum temperature in Kelvin and decimal part is the maximum temperature in Kelvin as 6 digits number (Obviously leading zeros and ending zeros could be omitted (and will not show in the memory setting after setting it) 000600. 100000 = 600. 1 Pressure Range is defined as following 000800. 002400 = 800 KPa to 2400 KPa the integer part of the number is the minimum pressure in KPa and decimal part is the maximum pressure in KPa as 6 digits number For example: Electrum Pressure 800KPa to 2,4Mpa=2400KPa Temperature 600K To 100000 Pressure Range Memory Value 000800. 002400 Temperature Range Memory Value 000600. 100000 Invar would be Pressure Range Memory Value 018000. 020000 Temperature Range Memory Value 001200. 001500 Set the ranges using other ic logic with the for the desired alloy (See this alloy range selector ic that is part of the collection) The furnace pressure will never aim for anything over the limit pressure of 55000Kpa (for safety reasons) Basic Setup: Required Parts -> 1 Ic Housing, 1 Ic Chip, 3 Tanks, 2 Logic Readers, 2 Logic Select (Kit Logic Processor), 3 Turbo Volume Pump (Gas), 1 Logic Switch, Pipes, Cables 3 Buffer Tanks 1 Tank with