Easy Advanced Furnace (All Metals)

This is an IC Program for running the Advanced Furnace. It is super simple to use and setup. For even easier use, I suggest my Advanced Furnace Display. This is the screen that displays which ore you have selected, as seen in the pictures and video above. You can find it here: https://steamcommunity.com/workshop/filedetails/?id=2714185920 You can try my Demo World Save that has the furnace already set up and running here: https://steamcommunity.com/sharedfiles/filedetails/?id=2715225698 If you find this useful, give it a thumbs up so others can find it easier. Required Items: (1) Advanced Furnace (1) Kit (IC Housing) (1) Integrated Circuit (IC10) (2) Kit (Logic Switch) (2) Volume Pump Mulitple chutes, pipes, cables, frames. 500kpa Fuel Supply Coolant Supply Labeller Tool Fuel Supply should be 2:1 Volatiles/Oxygen mix, at 500kpa. You can use a pressure regulator to drop the pressure down if you need to. Other pressures might work, but for safety reasons I keep my fuel lines at 500kpa. If you use a different pressure, you might need to adjust the fuel setpoint on line #18 ** Coolant should be either CO2, Nitrogen, or Pollutant. Any pressure should work. I use CO2 (since it is abundant on Mars) and keep it at 20c. Installation 1. Place the Advanced Furnace so that the entire furnace is inside of a frame (iron or steel) and only the front the furnace sticks out. See photo above. 2. Place a pipe in the shape of a T on the Input of the furnace, see photos above. 3. Place the volume pumps on the Tee fitting, so that both feed into the furnace. It is very important that each pump be only 1 pipe fitting away from the furnace. Again, see photos above. 4. Label each pump "Fuel Pump" and "Coolant Pump" respectively. 5. Pipe fuel and coolant to each pump. 6. Attach piping to Output of furnace, run this piping outside to a passive vent. Or you can capture and re-use the gasses coming out of the furnace, but keep in mind they will be very hot, and you should probably cool the