Gas Fuel Generator Power Control rev. 2

​​Overview This is a different version of Gas Fuel Generator Power Control that uses one single volume pump. Keep in mind that this version, unlike Pressure Regulator based, can be a bit more dangerous as you need to turn volume pump on/off at the same time as GFG to avoid overflowing Generator input. Although it's not really a problem and this IC10 code syncs on/off state. Details ​What you need: Gas Fuel Generator Fuel Pipe Analyzer (or similar device that provides info about fuel, such as Tank) Volume Pump IC10 housing and circuit What you get: You specify number of Watts you want to get from Gas Fuel Generator and it generates exactly that amount of power (with 99. 9999% accuracy) Fuel consumption: 10’000W = ~0. 279 moles of fuel per tick 100’000W = ~2. 79 moles of fuel per tick Fuel Temperatures: Fuel Temperature Max Power Output -144°C (Europa average) 169'210W -54. 616°C 100'000W -50°C 97'931W 0°C 80'005W 20°C 74'546W Setup: Also you need to place Pipe Analyzer on the fuel pipe somewhere OR you can use other device that provides Temperature and Pressure of your fuel pipe network (such as Tank if you store it there). IC10 setup: d0 — sensor that provides the Temperature and Pressure of the fuel line (I use Pipe Analyzer in the example), you can read the fuel Tank directly here as well d1 — whatever provides the needed Power output in Watts (I use Logic Memory in the example) d2 — Volume Pump d3 — Gas Fuel Generator This code will automatically turn volume pump on/off as you turn on/off the generator to avoid overflowing the generator input pipe.