Auto Fuel Mixer (Configurable)

Auto Fuel Mixer by gpedro178 This is a very simple code that will let you set up a Mixer without having to worry about blowing a pipe. It's also very commented to allow users to learn from it and to modify it if they want to do other types of mixtures like a breathing mixture or a greenhouse mixture. Requirements: 1 x Gas Mixer 3 x Pipe Analizer 1 x IC Housing 1 x IC Chip 1 x Labeller 1 x Computer with an IC Editor motherboard Enough Cable Setting up: Export the code to the IC Chip using a computer (You must connect an IC Housing data port to the computer data port) Set up your pipes in a way that the input 1 of the Gas Mixer is connected to the H2 line and the input 2 to the O2 line (or you can do it reversed but you should modify the line in the code with the setting for the mix else you'll get 2 part O2 per H2) Put a pipe analyzer in each of the input lines of the mixer and in the output line too Put your IC Housing in the analizer and mixer network and wire everything accordingly Label the Pipe Analizers and the Mixer to be able to recognize them in the network Put the IC Chip with the program in the IC Housing that will control the mixer and turn on the IC Housing Turn off the IC Housing, now the screws are named and you can set them to the mixer and the analizers accordingly If the screws where set correctly, now you can turn on the IC Housing and everything should be ok What's in the code? This code will set a mixer to produce a mix of 66. 67% of the input 1 and 33. 33% of the input 2 while locking the Mixer to avoid tampering. When it will stop? (Configurable) If the temp of any of the pipes is above 17°C (to avoid unexpected combustions) If the pressure of the O2 pipe is below 500 Kpa (to avoid depleting your O2 reserve) If the pressure of the H2 Pipe is below 20 Kpa If the pressure of the Fuel Pipe is above 20 Mpa (to avoid bursting a pipe) Important Notes Regarding Input Lines Temp: If the H2 line and the O2 line have a very different temp,