Sliverine's Climate Control

Designed to work with: - Multiple Wall Coolers - 1 filtration unit (targeted filter types are Pollutant X & CO2) - 2 LEDs showing the remaining filter level of the filtration unit - 1 active vent (venting to atmosphere for emergency overpressure venting) Features: - Modular. Add or remove devices from the system as needed. Operation of other devices will still continue and non-present devices skip their logic instead of causing the entire system to lock up in errors. The only exception to this is the gas sensor which is required. A reminder that adding or removing devices while IC is active and in operation may cause errors depending on which instruction is about to execute at that point, which can be resolved with a simple reset. - Unlocked overpressure vent. Users are still able to manually activate/deactivate overpressure vent without the system turning it off all the time. The system only turns off the vent IF it had to activate it at any point in time. Users can also freely toggle the vent's mode (just remember to set it back!) Note: Adding the LED requires a quick IC reset (remove & replace IC chip in housing) in order for LEDs to display correctly and in the right colours Required: - 1 IC Housing - 1 IC/10 Chip - 1 Batch Writer (Logic I/O) - 1 Gas Sensor Operation: - Turns on coolers when temperature >20 Celsius, otherwise turns it off - Turns on filtration when either CO2 or Pollutant >3%, otherwise turns it off - Turns on overpressure vent if kPa in base >105 kPa Instructions are further contained within code, as well as comments for some of the parameters. As this is a lightweight and customized piece of code, I did not create a config region for settings such as LED color and target temperature, nor did I include heater operation within as bases always seem to get too hot rather than too cold due to all the machines, lights and chargers inside. Tested working on Mars.