Air-Bus

Controls: WASD - Drive CTRL left & V - Propeller IJLK - Pitch & Roll O & P - Trim Elevator Up & Down B & N - Trim Ailerons Up & Down H - Lights On/Off Car-Mode: - Trim the elevator down (click O 15 times). - Use WASD normally. - To prevent tipping over you can use J & L in conjuction with A & D for steering, especially in sharp, fast turns. Plane-Mode: 1. Recommended Take-Off Procedure: - Set the elevator to the default position (click P 15 times when coming out of Drive-Mode). - Hold the handbrake (SPACE). - While holding the handbrake, spin up the Propeller by holding down CTRL left. - When the Propeller is up to speed, let the handbrake go and press W (drive forward) while still holding CTRL left to keep the Propeller going. - At around 220kph / 135mph pitch up with K to get lift off. - After lift off, let go of W to stop the engines powering the wheels. You can Press S to stop the engine quicker. - Use IJKL to steer the plane in the air. - Use O & P to trim the elevator to match your pitch to the speed. 2. Recommended Landing procedure: - Set the Ailerons to landing mode by pressing B 10 times. This angles the ailerons down and makes them act like landing flaps. - Cut power to the propeller by letting go of CTRL left. - Carefully adjust the elevator trim while gliding down to descent with a slow but steady pace. - After touch-down, press and hold S to brake. - Don't forget to reset the aileron trim after landing (click N 10 times)! NOTE: - You can use different values for the recommended trim values. It's just easier to reset the control surfaces to their default settings when using easy to remember numbers. - Of cource you can switch seamlessly from drive-mode to plane-mode. Just keep in mind that the propeller takes time to spin up (watch the rev-meter) and don't forget to set your trims correctly. - The Air-Bus was build and tuned under Atlas's . 26 community patch. (join the discord to get it!) Things may work a little different for you, depending on which ve