Air Suspension Kit

AIR SUSPENSION KIT

Street-performance air suspension for every car in My Garage.

FEATURES

• []Front and rear air springs - fit in place of the coil springs, the car keeps its own shock absorbers. They size themselves to every car.[/]

  []Air Kit - tank, compressor and valve block on one aluminium plate. Goes in the trunk, held by 4 bolts (wrench).[/]

  []Remote - a hand tool, hold it like the wrench (right-click). It controls the car you look at.[/]

  []Console panel - fits next to the gear stick, removed with the trim tool. The display opens when you sit in the car.[/]

  []Live display - mode, height of each wheel, tank pressure, compressor state and warnings.[/]

  []Sounds like a real air kit - when you raise, the compressor kicks in and you hear the air filling the bags; when you lower, the valves open with a loud "psssh" and the bags hiss as they deflate. Valve clicks on every button press.[/]

  []Works like a real air suspension - raising takes air from the tank (a full LOW to HIGH uses about 40 PSI), lowering lets the air out of the bags into the open air and does not use tank air. The compressor switches on below 150 PSI and off at 180 PSI. Without power the valves hold the air and the car keeps its height. Worn air springs slowly lose air and the compressor tops up now and then.[/]

  []Every car remembers its own last height, also after save and load.[/]

  []All parts are sold at LOUIS STORE (the wheel shop), on the "AIR SUSPENSION" display next to the counter.[/]

  CONTROLS

  (remote in hand, or sitting in a car with the panel)
  • []Insert / Home / Delete - LOW / NORMAL / HIGH[/]

    []Up / Down arrow (hold) - raise / lower, stops when you let go[/]

    []Left / Right arrow - axle: ALL / FRONT / REAR[/]

    []Page Up - compressor ON / OFF[/]

    []End - show / hide the display[/]

  All keys can be changed in the ModUtils mod settings.

  INSTALLING ON A CAR

  • []Air springs: fit them in place of the coil springs, with the spring compressor, like stock springs.[/]

    []Air Kit: put it in the trunk (a ghost shows the place) and tighten the 4 bolts. The compressor only runs with all bolts tight.[/]

    []Console panel: fits next to the gear stick (a ghost shows the place). Remove it with the trim tool.[/]

    []Power: battery, its main wires and ignition ON (the engine does not have to run).[/]

    []A new Air Kit comes with an empty tank - turn the ignition on and the compressor fills it in about 30 seconds.[/]

    REQUIREMENTS

    • []ModUtils 1. 3. 0 or newer (_SimplePartLoader.dll, !!ModUI.dll and the NewAutoupdater folder in the Mods folder).[/]

      INSTALLATION

      • []Install ModUtils.[/]

        []Put AirSuspension.dll into the game's Mods folder.[/]

        []If you have an older version, delete it first.[/]

        COMPATIBILITY

        All cars of the game and the W223 Brabus mod. Other modded cars use an automatic fit for the console panel.

        FOUND A PROBLEM?

        The kit was tested with the game's cars, but every car is different. If something looks or works wrong on any car (a part does not fit, the car sits too low or too high, the panel is in a bad spot, no sound, etc.), please tell me in the Posts or Bugs tab and include:

        • []the car name[/]

          []what you did and what went wrong[/]

          []a screenshot if possible[/]

          []the lines starting with from Player.log (C:\Users\<you>\AppData\LocalLow\Viking\My Garage\Player.log)[/]

        I will fix it in the next update.

        CREDITS

        Compressor, air release and valve sounds: Joseph Sardin, BigSoundBank (CC0).

        If you like the mod, please endorse it - it helps a lot!