One Punch!

PathWeaver A path-building assistant mod for Minecraft Forge. Select a road cross-section as a template, mark path points along the terrain, and generate a complete road with one click. Compatibility Minecraft : 1. 20. 1 Forge : 47.x Dedicated Server / LAN Multiplayer : Fully supported, with data stored separately for each player Getting the Item Craft the Path Weaver using 7 sticks in a crafting table with the following pattern: Stick Stick Stick Stick Stick Stick Stick You can also obtain it directly from the PathWeaver creative tab in Creative Mode. The item is non-stackable. Controls Overview Action Function Requirement Right-click block Mark selection corner / complete a selection region — Left-click block inside selection Delete that selection region Hold the tool and target a block inside an existing region Shift + Right-click block Confirm template (when selection regions exist) At least one region selected Left-click block Add path point Template confirmed, no active selection Shift + Right-click path point Remove that path point At least one path point exists Shift + Left-click block Generate path Template confirmed, enough path points Shift + Mouse Wheel Switch between LINEAR / BEZIER modes — Step 1: Select the Template Cross-Section The template is the road's cross-section . The tool repeats this cross-section along the path direction. Multiple selected regions are supported and merged as a union , which is useful for non-rectangular cross-sections. Basic Selection Right-click one corner block of the cross-section to mark Corner 1 (gold cross marker) Right-click the opposite corner block to mark Corner 2 and complete one selection region Repeat the above steps to add more regions; all regions are merged into the final template Face the forward path direction, then Shift + Right-click any block to confirm the template After confirmation, corner selections are cleared automatically, but the template is kept Re-selecting while a template already exists: the old template remains temporarily, and is replaced only after the new one is confirmed; all path points are cleared If path points already exist, right-clicking a block shows a confirmation prompt: "This will clear all current path points. Continue?" If Corner 1 is already set and you right-click a block: if there are no path points, it marks Corner 2; if path points exist, the action is rejected Delete a Selection Region Left-click any block inside an existing selected region to remove the smallest region containing that position Left-clicking outside the selection does not break the block; the action is intercepted Undo Selection /pathweaver undo corner - Cancel the current pending Corner 1 /pathweaver undo region - Remove the most recently added selection region Step 2: Mark Path Points After the template is confirmed, the tool enters path point mode. Left-click a ground block to add a path point, up to 256 points The XZ-plane projected distance from the new point to the previous poin