Bulk Placer

选中工具栏中的道路（小道）、栅栏或铁轨，按两下 V，即可在两点间自动铺满。

• []第一下 V：以正对格子为起点，并预览放置位置。[/]

  []第二下 V：走到终点再按 V，自动放置；物品不足时停止。[/]

  []C：切换模式（直线 / 矩形边框 / 矩形填充）。[/]

  []X：取消放置。[/]

  []手持铁轨时，自动切换为铁轨直线模式，仅支持直线铺设。[/]

快捷键可在 config 中配置。

• []直线模式：在起点与终点之间铺设一条直线。[/]

  []矩形边框模式：以起点和终点为对角，铺设矩形边框。[/]

  []矩形填充模式：以起点和终点为对角，填充整个矩形区域。[/]

  []铁轨直线模式：手持铁轨时自动启用，仅支持直线铺设铁路轨道。[/]

前三种按 C 键切换；铁轨模式根据手持物品自动生效。本 Mod 由 AI 辅助生成。

---

Select roads (paths), fences, or railway tracks in your toolbar, then press V twice to fill between two points.

• []First V: set the tile you're facing as the start and preview placement.[/]

  []Second V: go to the endpoint, press V again, and place items automatically. Stops when you run out.[/]

  []C: Switch mode (straight line / box outline / box fill).[/]

  []X: Cancel placement.[/]

  []When holding railway tracks, Rail mode is automatically enabled; only straight-line placement is supported.[/]

Hotkeys can be configured in the config file.

• []straight line: Places a straight line between the start and end points.[/]

  []box outline: Places a rectangular border using the two points as opposite corners.[/]

  []box fill: Fills the entire rectangular area between the two points.[/]

  []rail: Automatically active when holding railway tracks; only straight-line track placement is supported.[/]

The first three modes are switched with C; rail mode is determined by the held item.This mod was created with AI assistance.